• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 1362
  • Last Modified:

Cisco Port Suspended Mode

I have discovered two ports in an etherchannel that have entered Suspended mode.

A redundant uplink is maintaining the switch's connection, but I would like to restore the ports.

What can cause this behavior and what is the recommended solution?
1 Solution
Don JohnstonInstructorCommented:
A suspended port can be causes by a mismatch in the configuration. i.e. one side configured as a trunk and the other an access port. Or one side a trunk allowing VLANs 1-5 and the other a trunk allowing 3-10.
c-h-r-i-s-t-o-p-hAuthor Commented:
The physical ports were allowing an additional subnet vs the etherchannel
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

Featured Post

Get your problem seen by more experts

Be seen. Boost your question’s priority for more expert views and faster solutions

Tackle projects and never again get stuck behind a technical roadblock.
Join Now