APC Smart-UPS Extra Battery - no Powerchute

Hi

Just a sanity check really.

We have just bought an APC Smart-UPS 2200VA XLI + extra Battery unit.

I remember when we did this for our servers we had to specify the amount of extra battery packs installed within Powerchute to adjust runtime etc.

However this lot is going directly onto a dumb PBX, just wanted to make sure it would still correctly drain the extra battery pack before cutting out, even though there is no Powerchute sofware installed.
LVL 1
hongeditAsked:
Who is Participating?
 
CallandorConnect With a Mentor Commented:
The Powerchute software is there to shutdown attached servers smoothly before power goes out.  If you're just connecting it to a dumb PBX, there's no need to use Powerchute.  It doesn't affect the operation of extra batteries.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.