SEJOHNSON77
asked on
rd web access: only remoteapps work,
Hi,
Just configured remote access. I have all remote roles installed and configured. I can publish and run remote apps but I cannot use the remote desktop section of the site to connect to computers on my network. It just keep prompting for me to logon with a logon failed message every time.
Port 3389 is open on firewall and I tested to see if direct rdp works and it does.
Any suggestions?
Just configured remote access. I have all remote roles installed and configured. I can publish and run remote apps but I cannot use the remote desktop section of the site to connect to computers on my network. It just keep prompting for me to logon with a logon failed message every time.
Port 3389 is open on firewall and I tested to see if direct rdp works and it does.
Any suggestions?
ASKER
I have all roles installed on the one server with external access through some NAT rules on my router. Do I need to have two seperate machines for this to work?
No, you can do it on one without any further requirements.
You do need to configure BOTH a RD CAP and RD RAP.
http://technet.microsoft.com/en-us/library/cc732654.aspx
http://technet.microsoft.com/en-us/library/cc732654.aspx
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
1. Put each machine in public DNS, give static NAT and open up port 3389 to each machine
2. Install and configure Remote Desktop Gateway, which will accept https connections from the Internet and then send the connections to the destination server over 3389.