rrl22
asked on
ReadyNAS Pro will not complete volume scan
My ReadyNAS Pro will not complete a violume scan, therefore the data/volumes are not visible on the network even though you can see the storage unit itself.
I updated the firmware to Radiator 4.2.19. Data was visible for a couple hours today, but then it tried to run a voluime scan and stalled at 70%. I had no access through frontview so I turned the power off and rebooted. After the reboot I tried to use frontview to reboot and run volume scan. The reboot succeeds but volume scan will not run and data is not visible.
I've been working at this for 2 days. Earlier in the process drive 2 seemed to be having troubles. No problems were reported on "health" but drive 2 was resyncing, then later the numeral 2 was missing from the "box" on the unit. I removed the drive and reset it and then it acted normal. Data was visible for awhile, then down again.
ideas? Thanks!
I updated the firmware to Radiator 4.2.19. Data was visible for a couple hours today, but then it tried to run a voluime scan and stalled at 70%. I had no access through frontview so I turned the power off and rebooted. After the reboot I tried to use frontview to reboot and run volume scan. The reboot succeeds but volume scan will not run and data is not visible.
I've been working at this for 2 days. Earlier in the process drive 2 seemed to be having troubles. No problems were reported on "health" but drive 2 was resyncing, then later the numeral 2 was missing from the "box" on the unit. I removed the drive and reset it and then it acted normal. Data was visible for awhile, then down again.
ideas? Thanks!
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.