Solved

RedHat 5.4 Cluster - Changing Quorum Disk votes.  Reboot Required?

Posted on 2011-09-26
1
582 Views
Last Modified: 2012-05-12
Hello,

This is a simple question.  I need to change the Quorum Disk's Partition votes from 3 to 2.  If I do the change using LUCI (or directly in the cluster.conf), do I need to restart the cluster?

Thanks in advance!
Mark
0
Comment
Question by:nav_support
1 Comment
 
LVL 40

Accepted Solution

by:
noci earned 250 total points
ID: 36716304
From this manual:
http://docs.redhat.com/docs/en-US/Red_Hat_Enterprise_Linux/4/html/Cluster_Administration/s1-general-prop-conga-CA.html (3.4)
somewhere in the middle:
Note:
Clicking Apply on the Quorum Partition tab propagates changes to the cluster configuration file (/etc/cluster/cluster.conf) in each cluster node. However, for the quorum disk to operate, you must restart the cluster (refer to Section 4.1, “Starting, Stopping, and Deleting Clusters”).

So only the config file is updated & distributed (if using luci).
If luci isn't used then you need to edit the relevant file on all members..

0

Featured Post

Is Your Active Directory as Secure as You Think?

More than 75% of all records are compromised because of the loss or theft of a privileged credential. Experts have been exploring Active Directory infrastructure to identify key threats and establish best practices for keeping data safe. Attend this month’s webinar to learn more.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

rdate is a Linux command and the network time protocol for immediate date and time setup from another machine. The clocks are synchronized by entering rdate with the -s switch (command without switch just checks the time but does not set anything). …
I. Introduction There's an interesting discussion going on now in an Experts Exchange Group — Attachments with no extension (http://www.experts-exchange.com/discussions/210281/Attachments-with-no-extension.html). This reminded me of questions tha…
Learn how to find files with the shell using the find and locate commands. Use locate to find a needle in a haystack.: With locate, check if the file still exists.: Use find to get the actual location of the file.:
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

914 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

16 Experts available now in Live!

Get 1:1 Help Now