Solved

Configured from memory by console

Posted on 2011-09-27
3
1,751 Views
Last Modified: 2012-05-12
What exactly does "Configured from memory by console" mean?

I usually use "configure terminal"
0
Comment
Question by:Dragon0x40
  • 2
3 Comments
 
LVL 8

Expert Comment

by:akalbfell
ID: 36713245
That is just when the device loads the confi from NVRAM to memory
0
 

Author Comment

by:Dragon0x40
ID: 36713329
When a Master switch loads the config from its NVRAM to the Memory of the slave?
0
 
LVL 8

Accepted Solution

by:
akalbfell earned 500 total points
ID: 36713368
When a router or switch boots up it goes through a routine to check hardware, load the config, and I'm sure many other things. This is normally when you would see that message.

conf mem executes commands stored in NVRAM and copies the startup config to the running config.
0

Featured Post

Is Your Active Directory as Secure as You Think?

More than 75% of all records are compromised because of the loss or theft of a privileged credential. Experts have been exploring Active Directory infrastructure to identify key threats and establish best practices for keeping data safe. Attend this month’s webinar to learn more.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Can Cisco resolve internet address internally 4 31
Resource cost of NAT vs routing 3 64
traffic flow without STP 9 45
Ping Through ASA Firewall 6 20
This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices. This guide can be used on the following Ubiquiti AirMAX devices. Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. Please review …
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

912 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

23 Experts available now in Live!

Get 1:1 Help Now