The disk capacity must be at least ...MB to accommodate the total used space and minimum amount of free space.

XenConvert 2.0.2
Provioning Services Console Version 5.1.1.2950

Hello

I'm trying to make an image from the target device.  
During the XenConvert wizard, I get "The disk capacity must be at least 26914 MB to accomodate the total used space and minimum amount of free space."

I have a C drive (on the top line and is the only drive that shows up) on the target device,
 c:  usage %=56      Usage(GB)=19.71      Capacity(GB)=34.90
Provisioning Services vDisk:usage=-161668896 %      Usage(GB)=19.71      Capacity(GB)=0.00

I'm not sure why it's complaining about the size as the vDisk is 45GB whereas the target device VM is 35 GB with 15GB free so the vDisk size of 45 GB should be plenty.
LindowsAsked:
Who is Participating?
 
LindowsAuthor Commented:
Formatted the mounted vDisk and ran the wizard.  The conversion worked after that.
0
 
PradeepCommented:
The above error itself is saying that The disk capacity must be at least 26914 MB to accomodate the total used space and minimum amount of free space.
Whereas you are saying that free disk space is 15 gigs..
0
 
LindowsAuthor Commented:
15GB is free on the target device out of 35GB so only 20GB is actually being used on the target device.  
 
0
Ultimate Tool Kit for Technology Solution Provider

Broken down into practical pointers and step-by-step instructions, the IT Service Excellence Tool Kit delivers expert advice for technology solution providers. Get your free copy now.

 
Gerald ConnollyCommented:
Where does this message come from?

Provisioning Services vDisk:usage=-161668896 %      Usage(GB)=19.71      Capacity(GB)=0.00

it is showing a very large percentage usage which is negative and a capacity of 0!   What is all that about?
0
 
LindowsAuthor Commented:
The XenConvert Wizard.

ex.JPG
0
 
LindowsAuthor Commented:
I've requested that this question be closed as follows:

Accepted answer: 0 points for Lindows's comment http:/Q_27345209.html#36812932
Assisted answer: 0 points for Lindows's comment http:/Q_27345209.html#36720480

for the following reason:

Found the fix myself.
0
 
Gerald ConnollyCommented:
Its debateable if @Lindows fixed this without help, or was pointed in the right direction first.

Assign points to ID:36714745Author:Exchange9 and ID:36720108Author:connollyg
0
 
JustAModCommented:

All,

This thread has been reviewed by at least one moderator, and the decision has been made to restart the Auto Close process based on the original suggested disposition.

JustAMod
Community Support Moderator
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.