Solved

question on VTP domain and vlan trunking

Posted on 2011-09-28
2
365 Views
Last Modified: 2012-05-12
I have two 3550 switches.
I used gi0/1 and gi0/2 as trunking ports.
On both switches i configured the same vtp domain , one is server , the other client , vtp version 2 .
Then on both sides i did switchport trunk vlan allow all

but when i create a vln on server it doesnt replicate to the client.
When i do vtp counters i dont see any activity

Any ideas ?

0
Comment
Question by:c_hockland
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 18

Accepted Solution

by:
Garry Glendown earned 500 total points
ID: 36813004
What does "show vtp status" say on the two switches?
Which VTP version are you using, what's the VLAN IDs you create?
0
 

Author Comment

by:c_hockland
ID: 36813031
I created the etherchannel and vlans show up on the second switch now.
0

Featured Post

Optimum High-Definition Video Viewing and Control

The ATEN VM0404HA 4x4 4K HDMI Matrix Switch supports 4K resolutions of UHD (3840 x 2160) and DCI (4096 x 2160) with refresh rates of 30 Hz (4:4:4) and 60 Hz (4:2:0). It is ideal for applications where the routing of 4K digital signals is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Arrow Electronics was searching for a KVM  (Keyboard/Video/Mouse) switch that could display on one single monitor the current status of all units being tested on the rack.
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses
Course of the Month7 days, 23 hours left to enroll

617 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question