?
Solved

how to implement network Redundancy in cisco  catalyst 4506 e series

Posted on 2011-10-19
5
Medium Priority
?
505 Views
Last Modified: 2012-05-12
how to implement network redadancy  in cisco  catalyst 4506 e series
Removed the "Ubuntu" and the "Linux Distributions" Zones, and added the "Network Switches & Hubs" Zone instead.

rindi,
EE ZA Storage

Open in new window

0
Comment
Question by:greensuman
  • 3
  • 2
5 Comments
 
LVL 26

Expert Comment

by:Soulja
ID: 36995076
Please be more specific.

Hardware Redundancy?
- Multiple switches
-Multiple supervisors per chassis

Switch Path Redundancy?
- Multiple trunks/uplinks using spanning tree

L3 Path Redundancy?
- HSRP, GLBP, VRRP
- Dynamic routing using point to point L3 paths between switches.
0
 

Author Comment

by:greensuman
ID: 36997380
Hi ,

i am looking for hardware redundancy.in case of module fail or supervisor fail in the catalyst.

is it possible to use cisco 2600 router  to manage the hardware failure or what  will be the best solution to manage the situation

Thanks
suman
0
 
LVL 26

Expert Comment

by:Soulja
ID: 36999765
I don't understand what you mean by the 2600 router managing the hardware failure. Can you further expound?
0
 

Author Comment

by:greensuman
ID: 37010844
Hi ,

i am not an expert in  network hardware  .what i meant was .if the supervisor fails in the  catalyst.is it possible to manage  with cisco router 2600 with the remaing switches available in the catalyst.please guide on this .

Thanks
suman
0
 
LVL 26

Accepted Solution

by:
Soulja earned 2000 total points
ID: 37011877
If you have redundant supervisors in the catalyst switch the backup standby supervisor will take over if the primary one fails.
0

Featured Post

Vote for the Most Valuable Expert

It’s time to recognize experts that go above and beyond with helpful solutions and engagement on site. Choose from the top experts in the Hall of Fame or on the right rail of your favorite topic page. Look for the blue “Nominate” button on their profile to vote.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

The worst thing when starting a new job is when the previous Network Administrator left behind no documentation. How do you get into the devices? If you've been in this situation or just accidently mistyped your password, this article will hopefully…
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Loops Section Overview
Look below the covers at a subform control , and the form that is inside it. Explore properties and see how easy it is to aggregate, get statistics, and synchronize results for your data. A Microsoft Access subform is used to show relevant calcul…
Suggested Courses

840 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question