MrVault
asked on
Brocade switch show all output at once
When I do a "show run" on a brocade FWS or FCX ethernet switch, it shows a certain number of lines at once. I can press space to show another group at once. Is there anyway to tell it to show all lines at once?
ASKER
Sorry that is not available. "terminal length" is unrecognized. I'm using an FWS648G with versions below:
SW: Version 02.5.00aT3e1 Copyright (c) 1996-2006 Foundry Networks, Inc.
Compiled on Apr 08 2006 at 17:16:14 labeled as SXS02500a
(2029338 bytes) from Primary SXS02500a.bin
BootROM: Version 02.5.00Te6 (FEv2)
As well as an FCX648S
SW: Version 02.5.00aT3e1 Copyright (c) 1996-2006 Foundry Networks, Inc.
Compiled on Apr 08 2006 at 17:16:14 labeled as SXS02500a
(2029338 bytes) from Primary SXS02500a.bin
BootROM: Version 02.5.00Te6 (FEv2)
As well as an FCX648S
You must enter that command once in config mode, were you in config mode?
harbor235 ;}
ASKER
yes. if i go to config terminal mode and then do ? there's no terminal command at that level. outside config t mode (en) there's terminal but only "monitor" afterwards and that's to see the debug/log info on the screen.
I noticed your software image was compiled in 2006, perhaps your software is too old. I would research it for you but Foundry is awful with support. Perhaps it is also a limitation of that switch, these commands are present in other models.
Like I said, it would not surprise me
harbor235 ;}
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Command from other forum did the trick.
enter " terminal legth 0", this alows all lines to be dispalyed at once. Then afterwards you may want to set it back, "terminal length 24"
harbor235 ;}