IP Classless command Cisco 2960

I don't have the option for command "ip classless". (show up as % Unrecognized command)

Does this command only show up if ip routing is enabled?
Dragon0x40Asked:
Who is Participating?
 
rochey2009Commented:
LANBASE doesn't allow ip routing.
0
 
HellmarkLinux Systems AdministratorCommented:
Where are you trying to enter the command. If you're entering it in the wrong mode, then it will show as an unrecognized command.

And yes, typically IP Classless is used for routing. It basically means to not drop any packet, by not binding it to a specific network class. If you're not routing, then this won't come into play?
0
 
rochey2009Commented:
Hi,

Does your switch image support routing?

0
Ultimate Tool Kit for Technology Solution Provider

Broken down into practical pointers and step-by-step instructions, the IT Service Excellence Tool Kit delivers expert advice for technology solution providers. Get your free copy now.

 
Dragon0x40Author Commented:
I went into config mode and typed "ip routing ?" and it says %Unrecognized command.

Does that mean it does not support routing?
0
 
rochey2009Commented:
it does look like.

please post

show version
0
 
rochey2009Commented:
I mean, it doesn't look like.

please post

show version
0
 
Dragon0x40Author Commented:
the IOS is C2960-LANBASEK9-M
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.