jonas-p
asked on
Networking setup
Hello,
I'm have two switch in my network. The one i just bought Cisco Small Business SG200-26P.
And the other one in another room Cisco Small Business SD2008 v3 (8P).
Now i have multiple (about 3) cables (CAT6) going to the small switch (8P) from the main switch (26P). Now i want to use two cables from the 26P --> to the 8P so there is lot off bandwith.
Can i do this, or will i create a loop?
Thanks
I'm have two switch in my network. The one i just bought Cisco Small Business SG200-26P.
And the other one in another room Cisco Small Business SD2008 v3 (8P).
Now i have multiple (about 3) cables (CAT6) going to the small switch (8P) from the main switch (26P). Now i want to use two cables from the 26P --> to the 8P so there is lot off bandwith.
Can i do this, or will i create a loop?
Thanks
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.