We help IT Professionals succeed at work.

How to assign an IP address manually to new access point AIR 1142 N- A- K9

samee87
samee87 asked
on
Can you please tell me the procedure to assign IP adress manually to new access point.
Comment
Watch Question

Jimmy Larsson, CISSP, CEHNetwork and Security consultant

Commented:
Connect to the console.

enable
conf t
int bvi 1
 ip address 1.2.3.4 255.255.255.0
 no shut
!
wr mem

Best regards
Kvistofta
John MeggersNetwork Architect

Commented:
In the configurations I've done, I've put it on the BVI interface.

interface BVI 1
ip address 10.1.1.1 255.255.255.0

The radio and Ethernet interfaces are members of bridge-group 1.

Author

Commented:
I cannot connect the console. Can you please tell me the procedure to connect the console?
Maen Abu-TabanjehNetwork Administrator, Network Consultant
Top Expert 2011

Commented:
Network and Security consultant
Commented:
jordannet: That link is about LWAPP ap:s and has nothing to do with the current question.

samee87: You need a Cisco console-cable (light-blue). Connect it to the console port of the AP, and the other end to a computer with a serial-port. Use a terminal emulation software and configure it for that specific serial port and 9600 bps. Connect and you will get into the console.

Best regards
Kvistofta
Maen Abu-TabanjehNetwork Administrator, Network Consultant
Top Expert 2011

Commented:
your question is assign manual IP to this access point  , is there something i missed?

Author

Commented:
Good Job. Thank you