Cisco SG200-50 Setting up Trunk Group

I have recently purchased 2 Cisco 200-50, i wish to setup a Trunk Group to allow the 2 switches to be connected together for redundancy. How can i do this?
To-PC.doc
rtl_supportAsked:
Who is Participating?
 
SouljaCommented:
Here is a link for you:

https://supportforums.cisco.com/thread/2089054

You want to create at LAG (Link Aggregation Group)

There should be a section on your Menu to add the two ports you desire to a LAG.
0
 
rtl_supportAuthor Commented:
I have already setup this type of configuration using a HP switch and using Trunk Groups
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.