We help IT Professionals succeed at work.
Get Started

New Exchange 2010 Server Sending to Old

Last Modified: 2012-08-13
We have an exchange 2010 server that is running fine, but the server is going bad so we purchased a new server, installed exchagne 2010, updated to exactly what was on the other one and moved over all the mail boxes. Everything runs fine until i turn off or unplug the network from the other server. Then we are unable to send out emails. We can receive them just fine though. After turning the server back on (or plugging in) then all the emails that were sent go through. I can not for the life of me find out where to tell exchange not to route mail through that old server. Any ideas or suggestions?
Watch Question
This problem has been solved!
Unlock 1 Answer and 9 Comments.
See Answer
Why Experts Exchange?

Experts Exchange always has the answer, or at the least points me in the correct direction! It is like having another employee that is extremely experienced.

Jim Murphy
Programmer at Smart IT Solutions

When asked, what has been your best career decision?

Deciding to stick with EE.

Mohamed Asif
Technical Department Head

Being involved with EE helped me to grow personally and professionally.

Carl Webster
CTP, Sr Infrastructure Consultant
Ask ANY Question

Connect with Certified Experts to gain insight and support on specific technology challenges including:

  • Troubleshooting
  • Research
  • Professional Opinions
Did You Know?

We've partnered with two important charities to provide clean water and computer science education to those who need it most. READ MORE