I have a cisco aironet 1130 at the office for wireless connectivity to the network. This AP does Mac-Filtering, and I need to add a Mac-Address to access-list 700, which is the access list for Mac-filtering. My question is, when I do a "show access-list 700" on the WAP, it doesn't show the sequence number of the ACL's like it does on a Cisco router or switch. I normally use a sequence number so I can put the permit before the deny on the ACL. What I've been doing on this WAP, is removing the entire Access-list 700, paste it into notepad, and then add the permit for the new mac-address before the deny, and then paste the entire access-list back in again. Is there a way to just add one line to the ACL? I tried just removing the deny, but it got rid of the entire Access-list. Thanks.