troubleshooting Question

Cisco 1720 and 3600 Multilink

Avatar of jokerjoe6773
jokerjoe6773 asked on
RoutersNetworking Hardware-Other
7 Comments1 Solution477 ViewsLast Modified:
We have a Cisco 1720 and a Cisco 3600 that we would like to use multilink to bond 2 T1's together. We put a VWIC 2MFT-T1 in each Cisco and configured the ports to use multilink and everything seemed like it would work but we realized when we opened for business the next day that packs were being dropped in a big way...I would see pings at 4ms then 1100ms then time out. It got to the point where I had to go back in the config and take the multilink off and just drop one of the T1's. Is it possible to configure these two routers to do multilink? Not sure what info you need so just ask if this is not enough information.
Join the community to see this answer!
Join our exclusive community to see this answer & millions of others.
Unlock 1 Answer and 7 Comments.
Join the Community
Learn from the best

Network and collaborate with thousands of CTOs, CISOs, and IT Pros rooting for you and your success.

Andrew Hancock - VMware vExpert
See if this solution works for you by signing up for a 7 day free trial.
Unlock 1 Answer and 7 Comments.
Try for 7 days

”The time we save is the biggest benefit of E-E to our team. What could take multiple guys 2 hours or more each to find is accessed in around 15 minutes on Experts Exchange.

-Mike Kapnisakis, Warner Bros