Solved

Cisco 1841 using vwic2-2mft-t1/e1

Posted on 2012-03-14
5
529 Views
Last Modified: 2012-08-13
Can I use a vwic2-2mft-t1/e1 in a cisco 1841?
It is not letting me program the controllers.
0
Comment
Question by:mrbodjagles
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 4
5 Comments
 

Author Comment

by:mrbodjagles
ID: 37722053
Anyone?
0
 
LVL 32

Expert Comment

by:harbor235
ID: 37724851
What is your code version and can you see teh hardware if you issue the "show inventory" command?

harbor235 ;}
0
 

Author Comment

by:mrbodjagles
ID: 37749889
I can see the hardware if I so a show inventory.
The version is c1841-entbasek9.mz.150-1.M2.bin

Any ideas or suggestions would be most appreciated.
Thanks
0
 

Accepted Solution

by:
mrbodjagles earned 0 total points
ID: 37765859
I needed to add the "card type" command to get this to work.
0
 

Author Closing Comment

by:mrbodjagles
ID: 37790281
It is the correct answer
0

Featured Post

Forrester Webinar: xMatters Delivers 261% ROI

Guest speaker Dean Davison, Forrester Principal Consultant, explains how a Fortune 500 communication company using xMatters found these results: Achieved a 261% ROI, Experienced $753,280 in net present value benefits over 3 years and Reduced MTTR by 91% for tier 1 incidents.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

728 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question