Solved

asa 5505 bridged mode

Posted on 2012-03-17
1
256 Views
Last Modified: 2013-07-16
I am on site and having an issue connecting to the ISP through my asa5505. in the setup configuration it states.
Switch Configuration

NOTE: The configuration listed in this email is based on customer equipment that is connecting via Layer 2 device ("bridged").
Can my asa do bridged mode? I tried but they give me a
LAN IP gateway IP and subnet. If i enter the information as a static IP in my computer all works fine. but the asa will not allow me to set the default outside gateway. (or at least i may not know the command. Any help would be greatly appreciated.
0
Comment
Question by:ghaubrich
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 17

Accepted Solution

by:
lruiz52 earned 500 total points
ID: 37734140
You set "bridge mode" on the dsl/cable modem so that it passes the IP on to your ASA. The only thing you should need to do would be to change the outside IP on your ASA 5505 to the  public IP.

configure terminal
 ASA5505(config)# interface Vlan 2
 ASA5505(config-if)# nameif outside
 ASA5505(config-if)# security-level 0
 ASA5505(config-if)# ip address x.x.x.x x.x.x.x
 ASA5505(config-if)# no shut
  ASA5505(config-if)# exit
 
Assign Ethernet 0/0 to Vlan 2
interface eth 0/0
 switchport access vlan 2
0

Featured Post

Announcing the Most Valuable Experts of 2016

MVEs are more concerned with the satisfaction of those they help than with the considerable points they can earn. They are the types of people you feel privileged to call colleagues. Join us in honoring this amazing group of Experts.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Span IP Range across two sites via Cisco ASA Site-to-Site VPN 8 72
Setting up static routes to  sonicwll 4 101
Public DNS  Vs BGP 20 77
NAT/PAT unable to config correctly 7 68
It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
In the world of WAN, QoS is a pretty important topic for most, if not all, networks. Some WAN technologies have QoS mechanisms built in, but others, such as some L2 WAN's, don't have QoS control in the provider cloud.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question