Solved

Cisco 877W NAT and No NAT Config - blocking traffic

Posted on 2012-03-19
3
402 Views
Last Modified: 2012-03-20
Hi all

In the attached cisco config extract, computers on vlan 3 with IP addresses other than 172.16.16.2 can't connect to the internet.

Can anyone assist?

Thanks

Julian
20120319-config.txt
0
Comment
Question by:J-B
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 10

Accepted Solution

by:
mat1458 earned 500 total points
ID: 37740869
You have static NAT entries for 172.16.16.2 that use the .35 address. As you have not set the overload keyword in the NAT source list no other system can use this address anymore.

ip nat inside source list 190 pool SBS-LAN overload
0
 

Author Closing Comment

by:J-B
ID: 37744967
Many thanks
0
 
LVL 10

Expert Comment

by:mat1458
ID: 37745935
You're very welcome.
0

Featured Post

Optimum High-Definition Video Viewing and Control

The ATEN VM0404HA 4x4 4K HDMI Matrix Switch supports 4K resolutions of UHD (3840 x 2160) and DCI (4096 x 2160) with refresh rates of 30 Hz (4:4:4) and 60 Hz (4:2:0). It is ideal for applications where the routing of 4K digital signals is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
Tired of waiting for your show or movie to load?  Are buffering issues a constant problem with your internet connection?  Check this article out to see if these simple adjustments are the solution for you.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses
Course of the Month9 days, 3 hours left to enroll

617 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question