Solved

RDC to DLink DSL-G604T modem

Posted on 2012-03-19
1
560 Views
Last Modified: 2012-03-19
Please help. I have just changed the modem at our branch office to a DLink DSL-G604T. With the previous modem - Netgear- I could use RDC to connect through to the server for maintenance through port 3389. I cannot get connection through this modem no matter what I try. I just get the error message - Remote Desktop can't connect to the remote computer for one of these reasons: Remote access to the server is not enabled (It is), the remote computer is turned off or the remote computer is not available on the network.
Can some one give me step b y step on how to access remote server.

Thanks.

Gary
0
Comment
Question by:grussell87
1 Comment
 
LVL 37

Accepted Solution

by:
Bing CISM / CISSP earned 500 total points
Comment Utility
per the user guide below (page 58), they use Virtual Server as the term to define port forwarding for specific servers facing the internet.

just follow the screen instruction of Virtual Server and choose W2K Terminal, which is just RDP.

DSL-G604T Generation II ADSL2+ Wireless Modem Router
http://files.dlink.com.au/Products/DSL-G604T-GenII/Manuals/DSL-G604T_GenII_Manual_v1.11.pdf

hope it helps,
bbao
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Suggested Solutions

In a WLAN, anything you broadcast over the air can be intercepted.  By default a wireless network is wide open to all until security is configured. Even when security is configured information can still be intercepted! It is very important that you …
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

744 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

17 Experts available now in Live!

Get 1:1 Help Now