Solved

Site to Site VPN - Cradlepoint MBR1400 to Juniper SSG

Posted on 2012-03-22
1
2,112 Views
Last Modified: 2012-03-22
Hello,

I'm looking to set up a site to site vpn between our Juniper SSG20 and a Cradlepoint MBR1400. The SSG has a static IP, but the Cradlepoint has a dynamic IP... I'm assuming this is possible to accomplish, just need help how to do this / where to start.

Thanks!
0
Comment
Question by:scubablue
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 18

Accepted Solution

by:
Sanga Collins earned 500 total points
ID: 37753945
Here is an example of how to configure VPN to non-juniper equipment. It is from an older version of the firmware, but the same concepts apply almost exactly. you may find some settings in slightly different menu tree locations.

http://www.bluetrait.com/archive/2006/05/13/site-to-site-vpn-with-netscreen-5gt-and-netgear-dg834g/

The juniper will be able to handle a dynamic IP at the remote location. As long as you have a static IP on one side (the anchor) you will be able to create a stable VPN.

Hope this helps
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…
Suggested Courses

696 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question