Solved

HP bl870c i2 blade running hpux 11i v3 with hp apa

Posted on 2012-04-01
4
827 Views
Last Modified: 2012-04-08
after configuring  my hp bl870c i2 blade running hpux 11i v3 with hp apa connecting to a brocade swicthes my configure lan interfaces fail on reboot
0
Comment
Question by:lsbrown1
  • 3
4 Comments
 

Author Comment

by:lsbrown1
ID: 37794316
This is the error  I  get on bootup: "Configure LAN interfaces ............................ . FAIL *"
0
 
LVL 11

Expert Comment

by:diprajbasu
ID: 37796214
there are too many reason for the nic ...not to start.


the main important thing is whether the NIC shows the software state claimed , not unknown or no hardware.
if it is claimed then you can use sam to configure the NIC.

check first....

ioscan -knfC lan
lanscan
netstat -in
lanadmin -g 0
0
 

Accepted Solution

by:
lsbrown1 earned 0 total points
ID: 37804017
I have solved problem it was on the swicth side we change to LACP  to short vice long.
0
 

Author Closing Comment

by:lsbrown1
ID: 37820924
I have solved problem it was on the swicth side we change to LACP  to short vice long.
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Using libpcap/Jpcap to capture and send packets on Solaris version (10/11) Library used: 1.      Libpcap (http://www.tcpdump.org) Version 1.2 2.      Jpcap(http://netresearch.ics.uci.edu/kfujii/Jpcap/doc/index.html) Version 0.6 Prerequisite: 1.      GCC …
#Citrix #Citrix Netscaler #HTTP Compression #Load Balance
Learn how to get help with Linux/Unix bash shell commands. Use help to read help documents for built in bash shell commands.: Use man to interface with the online reference manuals for shell commands.: Use man to search man pages for unknown command…
In a previous video, we went over how to export a DynamoDB table into Amazon S3.  In this video, we show how to load the export from S3 into a DynamoDB table.

813 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

10 Experts available now in Live!

Get 1:1 Help Now