Go Premium for a chance to win a PS4. Enter to Win

x
  • Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 373
  • Last Modified:

Cisco, Access Points

Hey Guys,

Is there a way to have a Cisco 1130 Access Point have two different wireless networks (different vlans) and then the fa/0 be a trunking port to a cisco switch ?
0
supportemea
Asked:
supportemea
1 Solution
 
SEWS-ECommented:
I don't know about the 1300 models, I haven't used them before, but on other Cisco models you would need to create sub interfaces on the fa0/0 and dot11Radio interfaces. Then specify the vlan you want to use for each SSID.

Example: Using the native vlan1 for the SSID wlan01, and then creating a second ssid for wlan253, which uses trunking with vlan ID 253.

Note the use of the bridge groups to tie the dot11 sub interfaces and fastethernet subinterfaces.
 

dot11 ssid wlan01
   authentication open eap eap_methods 
   authentication network-eap eap_methods 
!
!	
dot11 ssid wlan253
   vlan 253
   authentication open eap eaptls_methods 
   authentication network-eap eaptls_methods
!
!
interface Dot11Radio0
 !
 ssid wlan01
 !
 ssid wlan253
 !
 bridge-group 1	
!	
interface Dot11Radio0.253
 encapsulation dot1Q 253
 no ip route-cache
 bridge-group 253
!
!
!
interface FastEthernet0
 no ip address
 no ip route-cache
 duplex auto
 speed auto
 bridge-group 1
 no bridge-group 1 source-learning
 bridge-group 1 spanning-disabled
!
interface FastEthernet0.253
 encapsulation dot1Q 253
 no ip route-cache
 bridge-group 253
 no bridge-group 253 source-learning
 bridge-group 253 spanning-disabled	

Open in new window

0

Featured Post

Veeam Task Manager for Hyper-V

Task Manager for Hyper-V provides critical information that allows you to monitor Hyper-V performance by displaying real-time views of CPU and memory at the individual VM-level, so you can quickly identify which VMs are using host resources.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now