verify Junos firewall policy

Is there a way to verify if I have setup a firewall policy correctly on Juniper SRX firewalls.
I am looking for something that is equivalent to the Cisco ASA 'packet tracer' where I can specify a source, destination on a specific port.

thanks
FREDARCEAsked:
Who is Participating?
 
deimarkCommented:
"show security match-policies" is the command you need bud.

Note, you will need to fill in ALL of the extra parameters like source address, destination address, source and destination port, protocol etc.
0
 
FREDARCEAuthor Commented:
works like a charm....    thanks
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.