Cisco L3 switch fiber connection

I am trying to find out if I have a fiber connection to my 4506 switch. This is the output that I got for show interface command:

GigabitEthernet2/5 is up, line protocol is up (connected)
  Hardware is Gigabit Ethernet Port, address is 000c.ce94.9f01 (bia 000c.ce94.9f01)
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
 ...
  Full-duplex, 1000Mb/s, link type is auto, media type is SX
biggynetAsked:
Who is Participating?
 
Nayyar HH (CCIE RS)Network ArchitectCommented:
Yes there is - it could be either - issue a " show module " to determine module type

SX - is Multi-mode fiber
0
 
Nayyar HH (CCIE RS)Network ArchitectCommented:
Yes - the output depicts this "media type is SX"
0
 
biggynetAuthor Commented:
So there is a fiber cable connect to the port and it is a GBIC module and not SFP. Correct?
What type of fiber is SX? Thx
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.