Avatar of madstylex
madstylex
 asked on

Loading a config file on HP Procurve 2610-24-PoE

Hi Experts,

I have a brand new HP Procurve 2610-24-PoE switch.  I have been given a config file to upload to it.  It is a text file and is on a folder on my C:.  Can anyone tell me how to load the config file through Hyper Terminal?

Thanks
Networking Hardware-OtherSwitches / Hubs

Avatar of undefined
Last Comment
Don Johnston

8/22/2022 - Mon
ASKER CERTIFIED SOLUTION
Don Johnston

Log in or sign up to see answer
Become an EE member today7-DAY FREE TRIAL
Members can start a 7-Day Free trial then enjoy unlimited access to the platform
Sign up - Free for 7 days
or
Learn why we charge membership fees
We get it - no one likes a content blocker. Take one extra minute and find out why we block content.
Not exactly the question you had in mind?
Sign up for an EE membership and get your own personalized solution. With an EE membership, you can ask unlimited troubleshooting, research, or opinion questions.
ask a question
RKinsp

just a side note, make sure you are in configuration mode before you paste.

from the cli prompt '#', type "configure terminal". This should change your prompt to (conf)#.

Then paste....
Don Johnston

Was there some aspect of my answer that did not meet your requirement?
This is the best money I have ever spent. I cannot not tell you how many times these folks have saved my bacon. I learn so much from the contributors.
rwheeler23