troubleshooting Question

HP switch loop back protection setup

Avatar of active8it
active8itFlag for United Kingdom of Great Britain and Northern Ireland asked on
HardwareNetwork Management
1 Comment1 Solution1145 ViewsLast Modified:
What are the commands required to ensure loop backs cannot occur on our network. We have x2 core 5406zl switches and various edge hps. We aren't too bothered about the edge but the core must have this protection. I'm led to believe it's possible to issue the command at cli but unsure what e best setup is and if it's ok to enable for all ports?
ASKER CERTIFIED SOLUTION
CPSAdmin

Our community of experts have been thoroughly vetted for their expertise and industry experience.

Join our community to see this answer!
Unlock 1 Answer and 1 Comment.
Start Free Trial
Learn from the best

Network and collaborate with thousands of CTOs, CISOs, and IT Pros rooting for you and your success.

Andrew Hancock - VMware vExpert
See if this solution works for you by signing up for a 7 day free trial.
Unlock 1 Answer and 1 Comment.
Try for 7 days

”The time we save is the biggest benefit of E-E to our team. What could take multiple guys 2 hours or more each to find is accessed in around 15 minutes on Experts Exchange.

-Mike Kapnisakis, Warner Bros