hidrau
asked on
Crystal Reports XI R2 Runtime (Delphi XE using Crystal VCL)
Hello everyone.
I've build a runtime installer from some Merge Modules (.msm files) i've found on some threads.
- CrystalReports11_5_RDC_Lic ense.msm
- CrystalReports11_5_RDC_Rep ortengine. msm
- CrystalReports11_5_RDC_Des igntime.ms m
- CrystalReports11_5_RDC_Run time.msm
But, when I make a full install (Full version and Editor from CD) it works pretty good and very fast, but, when I'm using this with any runtime installer it becomes so slow, i've made a test in a virtual machine to avoid the hardware differences.
Do you guys knows if there is any way to use only dlls like crystal 8.5? If not, where I can find the correct runtime installer or client installer? I look inside the CD or the installation folder and there was nothing. I'm using a VCL component for Delphi XE instead of using ActiveX.
Used VCL: vcl12cr11_5
Thanks anyway.
Best Regards,
Marcus;
I've build a runtime installer from some Merge Modules (.msm files) i've found on some threads.
- CrystalReports11_5_RDC_Lic
- CrystalReports11_5_RDC_Rep
- CrystalReports11_5_RDC_Des
- CrystalReports11_5_RDC_Run
But, when I make a full install (Full version and Editor from CD) it works pretty good and very fast, but, when I'm using this with any runtime installer it becomes so slow, i've made a test in a virtual machine to avoid the hardware differences.
Do you guys knows if there is any way to use only dlls like crystal 8.5? If not, where I can find the correct runtime installer or client installer? I look inside the CD or the installation folder and there was nothing. I'm using a VCL component for Delphi XE instead of using ActiveX.
Used VCL: vcl12cr11_5
Thanks anyway.
Best Regards,
Marcus;
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER