asked on

PIX configuration

I have following configuration in PIX
tcfw(config)# sh ip address
System IP Addresses:
ip address outside 66.51.70.110 255.255.255.248
ip address inside 172.16.0.1 255.255.255.0
ip address intf2 127.0.0.1 255.255.255.255
Current IP Addresses:
ip address outside 66.51.70.110 255.255.255.248
ip address inside 172.16.0.1 255.255.255.0
ip address intf2 127.0.0.1 255.255.255.255
ctcfw(config)# sh route
outside 0.0.0.0 0.0.0.0 66.51.70.105 1 OTHER static
outside 66.51.70.104 255.255.255.248 66.51.70.110 1 CONNECT static
inside 172.16.0.0 255.255.255.0 172.16.0.1 1 CONNECT static
inside 172.17.0.0 255.255.0.0 172.16.0.10 1 OTHER static
inside 172.18.0.0 255.255.0.0 172.16.0.10 1 OTHER static
inside 172.19.0.0 255.255.0.0 172.16.0.10 1 OTHER static
inside 172.19.0.1 255.255.255.255 172.16.0.10 1 OTHER static
inside 172.20.0.0 255.255.0.0 172.16.0.10 1 OTHER static

I need to change the wan IP and default gateway .
what command I should give on PIX

Thanks

ASKER CERTIFIED SOLUTION

max_the_king

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

992c8f4e3fa7030dd909172d55273a20

ASKER

Thanks let me try this and let you know.

992c8f4e3fa7030dd909172d55273a20

ASKER

what about DNS settings...? Do I have to change that ? Pl advise

max_the_king

Hi,
you should have no problem on DNS settings on Pix.
You didn't post the whole configuration, but please note that if you have some static nat on old public ip addresses, you'll have to change those ones as well with the new public IPs.
hope this helps
max

992c8f4e3fa7030dd909172d55273a20

ASKER

thanks