Subreport that is underlayed section of a Container report is showing odd results on multiple Pages

Posted on 2012-09-05
Last Modified: 2012-09-07
Hi Experts,

Going to try to explain this the best I can

The results I am getting from my report are varied between a 1 page report and subsequent pages... The first page if the data is fitting on 1 page is perfect.. the problems begin on the subsequent pages..

Currently i have a subreport which is in GH1h which is set to Underlay Following Sections, the problem is that if the data for either the subreport (GH1h)  or GH3a extends past the 1st page (respectively)  the First page of the main report is virtually blank (save for some sections above the GH1h section).. The 2nd page shows the GH1h information but the GH3a information doenst show till the 3rd page....

How can i get the first page of a multi page report to show data on the first page for both GH1h and GH3a and end whenever the last piece of data from either of these groups is displayed?
Question by:Mikeyman_01
    1 Comment
    LVL 100

    Accepted Solution

    Check the GROUP
    Right click GH! in the left margin
    On the second tab there is a KEEP GROUP TOGETHER OPTION
    Verify it is not checked.

    If that isn't the case
    Check the SECTION EXPERT

    Right click the GH! in the left margin
    Check if KEEP SECTION TOGETHER is checked

    If that isn't checked you may have NEW PAGE BEFORE set
    Depending on version paging control is either on the first tab (CR XI and before) or on its own tab (CR 2008 and later)
    If you have NEW PAGE BEFORE checked you need to use a formula
       Not OnFirstRecord;


    Featured Post

    Threat Intelligence Starter Resources

    Integrating threat intelligence can be challenging, and not all companies are ready. These resources can help you build awareness and prepare for defense.

    Join & Write a Comment

    Suggested Solutions

    Crystal Reports: 5 Tests for Top Performance It is complete, your masterpiece report.  Not only does it meet your customer’s expectations, it blows them out the water, all they want is beautifully summarised and displayed in a myriad of ways. …
    There have always been a lot of questions related to when Crystal Reports evaluates report components (such as formulas, summaries, cross-tabs, charts, to name a few examples). Crystal Reports uses a two-pass reporting process to provide greater …
    Hi everyone! This is Experts Exchange customer support.  This quick video will show you how to change your primary email address.  If you have any questions, then please Write a Comment below!
    how to add IIS SMTP to handle application/Scanner relays into office 365.

    734 members asked questions and received personalized solutions in the past 7 days.

    Join the community of 500,000 technology professionals and ask your questions.

    Join & Ask a Question

    Need Help in Real-Time?

    Connect with top rated Experts

    24 Experts available now in Live!

    Get 1:1 Help Now