PINOLE
asked on
Bridge mode configuration
is it possible to configure cisco router 2801 in bridge mode? I have a T1 frame from provider and I want to terminate to my PAN 200 that does not support T1 card, so I want to use the cisco 2801 that has a CSU/DSU WIC as bridge mode.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
thanks for the answer, what about line coding? encapsulation framerelay? do I need to specify that?
Yes. The serial interface will need to be configured for the F/R connection.
ASKER
what about PPP? would it work too?
Thank you
Thank you
That would depend on the circuit and your provider.
I have a T1 frame from providerI am assuming you meant frame-relay over T1.
ASKER