Phoenix43
asked on
Router Swap
I am having a branch "Swap" out a router with a bad fan remotely, which means I will be walking the branch manager thru this..
The replacement c2821 is on-site has the config pre-loaded already
What are the start to finish steps I need to take to make this quick and painless ?
The replacement c2821 is on-site has the config pre-loaded already
What are the start to finish steps I need to take to make this quick and painless ?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Wan connection to mpls edge router .. it also connected to a c3560 switch any considerations there?
Same router being replaced as router being removed.
Same router being replaced as router being removed.
ASKER
Just plugged in and powered on replacement 2821 i couldn't ping it tho ..What can I check.. i
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
The configs were done by sys admin..not avail at present and the router is located in another state..so I cant console in to the router.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Got the router communicating thanks, Turns out after walking on-site hands thru this install the router was not connected to the switch.
ASKER