Link to home
Start Free TrialLog in
Avatar of jacksch4820
jacksch4820

asked on

Cisco etherchannel question

I need to configure an etherchanel.
My question is where must I configure the following commands.

switchport trunk native vlan 10
 switchport trunk allowed vlan 99
 switchport mode trunk
 switchport nonegotiate
 speed nonegotiate
 udld port aggressive

On the physical interface (e.g. interface gi1/0/1) or on the logical interface (interface port-channel)
Please advice.
Avatar of fgasimzade
fgasimzade
Flag of Azerbaijan image

switchport trunk native vlan 10
 switchport trunk allowed vlan 99
 switchport mode trunk
 switchport nonegotiate

This one goes to logical interface

No sure about the speed though. I believe it should be on the physical interface
Avatar of jacksch4820
jacksch4820

ASKER

Okay thanks and these commands last ones

switchport trunk encapsulation dot1q
udld port aggressive
 storm-control broadcast level 80.00 75.00
 storm-control multicast level 80.00 75.00
 storm-control unicast level 80.00 75.00
 spanning-tree guard root
SOLUTION
Avatar of fgasimzade
fgasimzade
Flag of Azerbaijan image

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
storm-control unicast level work on both
ASKER CERTIFIED SOLUTION
Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
okay but udld goes onto members right