Link to home
Start Free TrialLog in
Avatar of ITBUFF
ITBUFF

asked on

cisco 867vae-k9 adsl2 initial setup

can't seem to get the adsl2 modem working with the internet.

using optus pots line for adsl with the following "correct" specs:

PPPoE
vpi=8
vci=35
selecting dynamic mode

i've gone into ssh to change uname/pword   using config t then saved using copy runiing-config

all good so far.

then I loaded the CP express app from ie9 and input the values listed above without drama.

when adding a new connection I select pppoe, after that it only shows options for that type of connection.

So I get green lights in the CP panel (not on modem)

no errors shown, don't know what else to do.

So my question is do I need to go further into the interface using ssh to configure the modem to work ?

what are the steps I have to take  to get simple pots  adsl to work ! ? :)
ASKER CERTIFIED SOLUTION
Avatar of Matt V
Matt V
Flag of Canada image

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of ArneLovius
if you can post a suitably sanitized copy of the config