Solved

Rate limit on Cisco Router

Posted on 2012-12-25
1
882 Views
Last Modified: 2012-12-25
Hello Experts:

I have a Cisco Router 3800 series router, i Would like to use the rate-limit on specific traffic for certain subnets.  

interface GigabitEthernet0/0
rate-limit input access-group (Port) 128000 64000 64000 conform-action transmit exceed-action drop

For the Access List I have tried to use this command but it does not work.
access-list 80 permit tcp any eq www host 192.168.10.0 0.0.0.255

thanks for your help
0
Comment
Question by:itubaf
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 16

Accepted Solution

by:
Syed_M_Usman earned 500 total points
ID: 38720616
0

Featured Post

Free learning courses: Active Directory Deep Dive

Get a firm grasp on your IT environment when you learn Active Directory best practices with Veeam! Watch all, or choose any amount, of this three-part webinar series to improve your skills. From the basics to virtualization and backup, we got you covered.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Cisco ASA 5505's for VPN study 15 64
Static Route on Cisco ISR 4431's 4 35
SMPS issue 1 44
Urgent !I am connecting a cisco catalyst 3560 switch amber light on port 15 51
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

697 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question