asked on

IBM Bladecenter Nortel switch issue

Dear EE,

We have a IBM Bladecenter with integrated Nortel switch.
The problem is I am not able to change anything on the switch because I am getting the following errors:

>> azimov-in - Main# diff
Diff is issued by another user. Try later.

>> azimov-in - Main# revert
Confirm reverting unapplied changes [y/n]: y
Diff is issued by another user. Try later.

Open in new window

Bladecenter is on the remote location. I think one reload will solve problem but what if I can't boot a switch?

Can you help me to remove these errors or what is the best option for me. Let me mention that no one at this location

ASKER CERTIFIED SOLUTION

Syed Muhammad Usman

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

nmeaux

ASKER

Hi,

This is information about system

>> azimov-in - System# general
System Information at 10:48:25 Thu Dec 27, 2012
Time zone: No timezone configured

Nortel Layer2-3 GbE Switch Module(Copper)

Switch has been up for 48 days, 6 hours, 12 minutes and 37 seconds.
Last boot: 13:16:09 Thu Oct 28, 2010 (power cycle)

MAC Address: xx:xx:xx:xx:xx:xx    Management IP Address (if 128): xxx.xxx.xxx.xxx
Software Version 1.3.2.0 (FLASH image2), active configuration.

PCBA Part Number:      317857-C
FAB Number:            EL4512029
Serial Number:         YJ1JXF76C393
Manufacturing Date:    0724
Hardware Revision:     1
Board Revision:        2
PLD Firmware Version:  1.0

Temperature Sensor 1 (Warning):   39.5 C (Warn at 77.0 C/Recover at 72.0 C)
Temperature Sensor 2 (Shutdown):  38.5 C (Warn at 90.0 C/Recover at 80.0 C)

Switch is in I/O Module Bay 1


>> azimov-in - System#

Open in new window

Probably IBM support is not free. It is reason why I asked EE :)

Any other solution

Cheers

nmeaux

ASKER

Also, we are looking for someone who wants to take responsibility and install new IOS and reload a switch.

Best,

lihnjoATTgmailDOOTcom

nmeaux

ASKER

I re-installed to new IOS and reboot switch.