Solved

Catalyst IE3000 SNMP Optical RX Power OID

Posted on 2013-01-08
1
334 Views
Last Modified: 2014-02-19
Dear experts!

I'm looking for the OID string on a IE-3000 switch to give me the results for the optical Tx and Rx power as shown in the "show interface transceiver" command (this is the output i ran directely from the IE-3000 switch, BTW):
 
                                 Optical   Optical
           Temperature  Voltage  Tx Power  Rx Power
Port       (Celsius)    (Volts)  (dBm)     (dBm)
---------  -----------  -------  --------  --------
Gi1/1        30.1       3.29      -6.1      -7.3
 
 
The OID I am using on our 6509 switch for Rx power is .1.3.6.1.4.1.9.9.91.1.1.1.1.4.xxx (where xxx is the ifindex number), but I can't seem to find anything similar for it on the IE3000.  
 
Thanks for any help!
0
Comment
Question by:Khitrov
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 22

Accepted Solution

by:
Jody Lemoine earned 500 total points
ID: 38760089
What version of the switch IOS do you have? According to my information, that MIB should be supported on the IE3000 with the IP Services (or better) feature set in the following versions:

12.2(52)SE
12.2(52)SE1
12.2(53)SE
12.2(55)SE
12.2(55)SE1
12.2(55)SE3
12.2(55)SE4
12.2(55)SE5
12.2(55)SE6
12.2(58)SE
12.2(58)SE1
12.2(58)SE2
15.0(2)SE
0

Featured Post

Announcing the Most Valuable Experts of 2016

MVEs are more concerned with the satisfaction of those they help than with the considerable points they can earn. They are the types of people you feel privileged to call colleagues. Join us in honoring this amazing group of Experts.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

691 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question