[2 days left] What’s wrong with your cloud strategy? Learn why multicloud solutions matter with Nimble Storage.Register Now

x
?
Solved

Cisco QoS Configuration

Posted on 2013-01-18
5
Medium Priority
?
608 Views
Last Modified: 2014-09-03
I need help configuring a remote office firewall to allow great Voice over IP.  I have configure the QoS Port Based Settings to Port on the LAN interface that the VOIP phone is on which must connect to a Hosted PBX system.  I have set it to the Highest Priority then have configured CoS traffic forwarding queues to highest (4) for CoS priority 5, 6, 7 and selected the proper interface.  I am not very savvy with VOIP CoS prioritization and I could really use some help to figure out how to provide the best VOIP quality on this small 1 computer, 1 VOIP phone office sitting behind a Cisco RV215W router which connects to a Broadband modem and is seeing 10Mb down and 1 Mb up.  Bandwidth management is set to  a lower upstream and downstream 850k up and 9500 down. and I have enabled SIP service TCP and UDP 5060/5061 High Priority on both upstream and downstream.  I am attaching some images of the settings page I have and have turned on logging informational
BandwidthManagement.JPG
CoS-Settings.JPG
DSCP-Settings.JPG
QoS-Port-Based-Settings.JPG
0
Comment
Question by:apscnjohnnie
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
5 Comments
 

Accepted Solution

by:
apscnjohnnie earned 0 total points
ID: 38810552
Thanks SouthMod.  I guess I'll have to make a call in to Cisco.  I'd be happy to turn over the points if I could get some guidance of any kind.
0
 
LVL 1

Expert Comment

by:robertmparten
ID: 39747713
Is your VoIP phone set to mark the packet with DSCP value 46 and have the switch trust the DSCP value? Is your PBX hosted on-site or hosted?
0
 

Author Closing Comment

by:apscnjohnnie
ID: 40300555
No suitable answer was provided during the time I had the issue.
0

Featured Post

Visualize your virtual and backup environments

Create well-organized and polished visualizations of your virtual and backup environments when planning VMware vSphere, Microsoft Hyper-V or Veeam deployments. It helps you to gain better visibility and valuable business insights.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

A 2007 NCSA Cyber Security survey revealed that a mere 4% of the population has a full understanding of firewalls. As business owner, you should be part of that 4% that has a full understanding.
In this article, we’ll look at how to deploy ProxySQL.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
In this video we outline the Physical Segments view of NetCrunch network monitor. By following this brief how-to video, you will be able to learn how NetCrunch visualizes your network, how granular is the information collected, as well as where to f…
Suggested Courses

656 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question