Solved

Prevent browsing  Linksys WAP4400N

Posted on 2013-01-18
1
415 Views
Last Modified: 2013-02-07
How can I change the settings of the WAP4400N to prevent users from browsing to each others PC's once they connect to the WIF network? Also, how do I prevent browsing of the wired LAN that the unit is attached to?
0
Comment
Question by:HardwareDude
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 44

Accepted Solution

by:
Darr247 earned 500 total points
ID: 38795610
In the AP's web-based setup menus, look in Wireless->Wireless Security for a Wireless Isolation (within SSID) option. If you set that to Enabled, it should prevent clients from browsing other wireless devices while connected.

The WAP4400N does not have a firewall nor any type of routing capabilities. It acts much like a hub except it's full duplex instead of simplex like hubs were, and you can make it act like a wireless switch instead by enabling the Wireless Isolation option in Wireless->Wireless Security.

You'll need to put another appliance between your LAN and the AP if you want to keep its wireless clients from talking to the rest of your LAN, too.
0

Featured Post

Connect further...control easier

With the ATEN CE624, you can now enjoy a high-quality visual experience powered by HDBaseT technology and the convenience of a single Cat6 cable to transmit uncompressed video with zero latency and multi-streaming for dual-view applications where remote access is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Join Greg Farro and Ethan Banks from Packet Pushers (http://packetpushers.net/podcast/podcasts/pq-show-93-smart-network-monitoring-paessler-sponsored/) and Greg Ross from Paessler (https://www.paessler.com/prtg) for a discussion about smart network …
When you try to share a printer , you may receive one of the following error messages. Error message when you use the Add Printer Wizard to share a printer: Windows could not share your printer. Operation could not be completed (Error 0x000006…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
In this tutorial you'll learn about bandwidth monitoring with flows and packet sniffing with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're interested in additional methods for monitoring bandwidt…

751 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question