Solved

task shaduler dont run

Posted on 2013-01-20
1
333 Views
Last Modified: 2013-02-14
i have task shaduler on server 2008 and i see that he dont run ,but if i click on it manualy he run what can be the problem?
0
Comment
Question by:buildingit
1 Comment
 
LVL 7

Accepted Solution

by:
ded_ch earned 500 total points
ID: 38798432
There could be many reasons why it would not run.

- There could be a permission problem with the account entered to run the task.
- There could be a setting problem. For example the job is set to only run when somebody is logged on. Check all your settings and make sure they are correct.
- If in your task, a mapped network drive is used. The mapped drive might not be available in the session of the user under which the task runs. In this case use UNC Paths instead of the mapped drive.

Post the error code that is displayed in Task scheduler (e.g. 0x2) You should see it next to the task once it unsuccessfully ran.
This might give us a pointer to the issue.
0

Featured Post

Backup Your Microsoft Windows Server®

Backup all your Microsoft Windows Server – on-premises, in remote locations, in private and hybrid clouds. Your entire Windows Server will be backed up in one easy step with patented, block-level disk imaging. We achieve RTOs (recovery time objectives) as low as 15 seconds.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Recently, I was asked to look into SCCM 2007 by my employer, having a degree of experience of earlier versions of SMS and some previous SCCM knowledge I didn't expect the procedure to involve to much time. I read a number of guides concerning it…
A safe way to clean winsxs folder from your windows server 2008 R2 editions
This tutorial will walk an individual through locating and launching the BEUtility application to properly change the service account username and\or password in situation where it may be necessary or where the password has been inadvertently change…
This tutorial will walk an individual through the steps necessary to join and promote the first Windows Server 2012 domain controller into an Active Directory environment running on Windows Server 2008. Determine the location of the FSMO roles by lo…

911 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

22 Experts available now in Live!

Get 1:1 Help Now