archie4720
asked on
Hardware Conference bridge in a Cisco 2911
I have a 2911 with this software running: System image file is "flash0:c2900-universalk9- mz.SPA.151 -4.M4.bin" . I am trying to setup a conference bridge to allow conferencing between G711 and G729. In building the dspfarm profile an available command is codec. When I enter this command I do not have any choices as to what it allows and anything entered after this command gets:
USGJ1RT001(config-dspfarm- profile)#c odec g711ulaw
^
% Invalid input detected at '^' marker.
Looking for a solution that will allow conferencing between a site with G711 and one with G729
USGJ1RT001(config-dspfarm-
^
% Invalid input detected at '^' marker.
Looking for a solution that will allow conferencing between a site with G711 and one with G729
Are you running a call manager? Full or CME?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Found I had missed the bind command and did find that in the Cisco document. Still had trouble getting sccp to associate and we are using 4 port T1 cards using Multilink for the WAN connection. The CUCM couldn't see the IP of the Multilink interface and when pointed towards the tunnel instead they came up and registered.