Solved

Cisco UCM 7.1 - blocking robo calls

Posted on 2013-01-29
2
916 Views
Last Modified: 2013-01-29
I have had a few incidents where a robo call will call one of my DIDs 4, 6 times simultaneous - with some odd results.  I can not get in contact with whoever owns that number as when I call it - the only option is to enter a code that of course I don't know.  Anyhow - I was looking for advise o how best to block these.  I connect to the PSTN via a SIP trunk from my 3845 ISR.  Would the blocking be best done at that point?  And what would be the most efficient means to implement a sort of SIP access list to send calls from that number to the bit bucket?
0
Comment
Question by:amigan_99
2 Comments
 
LVL 20

Accepted Solution

by:
José Méndez earned 500 total points
ID: 38832704
This might help you blocking the incoming call from the gateway, CM 7.1 doesn't have what it takes to discriminate calls based on the calling number:

https://supportforums.cisco.com/docs/DOC-25415
0
 
LVL 1

Author Closing Comment

by:amigan_99
ID: 38833200
Perfect.  Thank you!
0

Featured Post

Connect further...control easier

With the ATEN CE624, you can now enjoy a high-quality visual experience powered by HDBaseT technology and the convenience of a single Cat6 cable to transmit uncompressed video with zero latency and multi-streaming for dual-view applications where remote access is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

In the world of WAN, QoS is a pretty important topic for most, if not all, networks. Some WAN technologies have QoS mechanisms built in, but others, such as some L2 WAN's, don't have QoS control in the provider cloud.
As companies replace their old PBX phone systems with Unified IP Communications, many are finding out that legacy applications such as fax do not work well with VoIP. Fortunately, Cloud Faxing provides a cost-effective alternative that works over an…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

765 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question