Solved

snmp-server chassis-id

Posted on 2013-01-29
5
939 Views
Last Modified: 2013-02-28
I have a Catalyst 2960 series and there is a statement snmp-server chassis-id 0x07. How do I verify that it is the correct the chassis ID. Show version did not show any chassis id. Thanks
0
Comment
Question by:biggynet
  • 3
  • 2
5 Comments
 
LVL 57

Expert Comment

by:giltjr
ID: 38832830
That is setting what the switch will show when somebody queries the switch for its chassis id.

By default the chassis id is normally the serial number.  Don't know why somebody would have changed it to 0x07, unless they were numbering the switches in the network and was using this field to show which switch it was.

You can use the command:

no snmp-server chassis-id 0x07

to remove it.  Search for "chassis-id" in the reference below:

Ref: http://www.cisco.com/en/US/docs/ios/12_2/configfun/command/reference/frf014.html#wp1022386
0
 

Author Comment

by:biggynet
ID: 38886239
I do not want to remove it. I'd like to get the chassis ID that match my switch. Thx
0
 
LVL 57

Expert Comment

by:giltjr
ID: 38886406
Not sure if you have to "no" it first, but the following should take care of it.

no snmp-server chassis-id 0x07
snmp-server chassis-id whateveryouwant
0
 

Author Comment

by:biggynet
ID: 38886567
So the chassis ID is not an identification tat you get from your switch. It is something that you arbitrarily assign to the chassis. Correct?
0
 
LVL 57

Accepted Solution

by:
giltjr earned 500 total points
ID: 38887318
No.  By default the chassis id is the chassis's serial number.

If you want to use that, then you just:

no snmp-server chassis-id 0x07

then do

show snmp-server chassis-id
0

Featured Post

Efficient way to get backups off site to Azure

This user guide provides instructions on how to deploy and configure both a StoneFly Scale Out NAS Enterprise Cloud Drive virtual machine and Veeam Cloud Connect in the Microsoft Azure Cloud.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
adding a printer to QAD 10 62
Advertise subnet not directly attached 6 30
route-map permit with a number 1 18
Etherchannel balancing 10 19
PRTG Network Monitor lets you monitor your bandwidth usage, so you know who is using up your bandwidth, and what they're using it for.
ADCs have gained traction within the last decade, largely due to increased demand for legacy load balancing appliances to handle more advanced application delivery requirements and improve application performance.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

805 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question