asked on

How to setup QOS for voice on a HP 1910 switch

My customer has an allworx phone system with about 20 phones. They have 40 workstations. All of it was running over a 10/100 netgear switch. I have installed 2 new switches - Hp v1910-48G for the data and a HP 1910-24G POE for the phones. So now that I have physically separated the switches, I see no point in VLAN'ing, but I would think since the switches are still connected (phone system talks to server) I think QoS would still be useful. I have never had the need to setup QoS before on a layer 3 switch, so any help in this area would be helpful. I've attached a screen shot so you can see all my options...
ss.jpg

agonza07

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&taskId=120&prodSeriesId=4218346&prodTypeId=12883&objectID=c03067142

Refer to section on 'Voice VLAN configuration' where it states:

A voice VLAN is configured especially for voice traffic. After assigning the ports connecting to voice devices to a voice VLAN, the system automatically configures quality of service (QoS) parameters for voice traffic, improving the transmission priority of voice traffic and ensuring voice quality.

phirenetworks

ASKER

I understand that if I configure a voice VLAN it will automatically employ QoS on it, but I dont want another VLAN - I just want QoS

ASKER CERTIFIED SOLUTION

agonza07

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial