bikerhong
asked on
Send as Distribution Group Exchange 2010 - permissions reverting?
Hi all
I am trying to set permissions for users to be able to send as a distribution group (i.e info@)
Using the command:
Set-DistributionGroup "Info" -GrantSendOnBehalfTo User
This command works.
However, within a few minutes (if that) - the permission goes away and when trying to Send As, the user gets an NDR.
I've come across this before in that the user USED to be part of an admin group - so I have cleared the admincount AD attribute to 0 and also re-enabled permission inheritance.
I'm sure this fixed it before but it's still happening.
Any idea?
I am trying to set permissions for users to be able to send as a distribution group (i.e info@)
Using the command:
Set-DistributionGroup "Info" -GrantSendOnBehalfTo User
This command works.
However, within a few minutes (if that) - the permission goes away and when trying to Send As, the user gets an NDR.
I've come across this before in that the user USED to be part of an admin group - so I have cleared the admincount AD attribute to 0 and also re-enabled permission inheritance.
I'm sure this fixed it before but it's still happening.
Any idea?
Amit
create one test user and check and everything works with test user.
It usually happens because of two reasons either outlook not configured correctly or
conflicting permissions; since in your case permission gets reverted it has to be a permission issue.
Is it possible that the block inheritance is enabled if not check for the effective permissions of the group especially for any deny´s set on the ACL for the users. You could also try doing it from scratch with new distribution group and user
It's definitely a permission issue- provided the permissions are getting reset. Try looking into that in detail and you'll definitely find the problem.
conflicting permissions; since in your case permission gets reverted it has to be a permission issue.
Is it possible that the block inheritance is enabled if not check for the effective permissions of the group especially for any deny´s set on the ACL for the users. You could also try doing it from scratch with new distribution group and user
It's definitely a permission issue- provided the permissions are getting reset. Try looking into that in detail and you'll definitely find the problem.
What is the SP and RU for Exchange ?
What if you manually set the settings using EMC GUI ?
- Rancy
What if you manually set the settings using EMC GUI ?
- Rancy
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
As per comment