Link to home
Start Free TrialLog in
Avatar of ETI2010
ETI2010Flag for United States of America

asked on

VoIP traffic through Site to Site VPN CISCO ASA 5505

I have a site to site VPN setup with 2 Panasonic phone systems on either side.  I have the configuration setup where I can call the other site and sometimes it will work and other times it'll ring busy.  I would assume that my site to site is working just fine since it works sometimes and not others.  I talked to Panasonic and they said it's probably a packet loss situation.  Just wondering if someone could take a look at my configurations on the ASA and see if I have everything opened that I need to.  Attached are the configurations and the ports needed to be opened.

I also ran a packet loss test for both sites for an hour on Friday.
New Ulm:  
http://www.hostmycalls.com/isptest/rp.html?Route=RP000009620130321150800&Project=PRO000002820130321150800&Jstart=3/21/2013%202:08:00%20PM&Jstop=3/21/2013%203:04:00%20PM&PName=newulm&Offset=-5

Clear Lake:
http://www.hostmycalls.com/isptest/rp.html?Route=RP000009520130321150700&Project=PRO000002720130321150700&Jstart=3/21/2013%202:07:00%20PM&Jstop=3/21/2013%203:03:00%20PM&PName=clearlake&Offset=-5

Any suggestions?
CLEAR-LAKE.txt
NEW-ULM.txt
PANASONIC-IP-Ports-REVISED-2012.pdf
Avatar of lruiz52
lruiz52
Flag of United States of America image

I had a similar issue and adding the below fixed it. I noticed you don't have them in your config.  Try and let us kno

policy-map global_policy
class inspection_default
inspect rtsp
inspect sip
Avatar of ETI2010

ASKER

It gives me an error when doing the last 2 lines.


Result of the command: "inspect rtsp"

inspect rtsp
  ^
ERROR: % Invalid input detected at '^' marker.



Result of the command: "inspect sip"

inspect sip
  ^
ERROR: % Invalid input detected at '^' marker
Avatar of ETI2010

ASKER

Does my configuration look ok that it wouldn't be the ASA?  Would it fall to the ISP?
ASKER CERTIFIED SOLUTION
Avatar of lruiz52
lruiz52
Flag of United States of America image

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial