Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people, just like you, are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
Solved

Cisco Dialer Interface Spoofing Error Help

Posted on 2013-05-15
2
659 Views
Last Modified: 2013-05-15
Hello Experts,

I'm trying to connect to my ISP over DSL. I have configured the the ATM interface and the dialer, however I can't get out on the internet.

Also, I'm getting the following error message on the dialer interface

ISR_G2_1921#show int dialer 1
Dialer1 is up (spoofing), line protocol is up (spoofing)

Don't usually ask for expeditious help but you early response will be greatly appreciated.

I have attached the configs.

Thanks guys/girls

Carlton
11-42-30--Serial-COM.txt
0
Comment
Question by:cpatte7372
2 Comments
 
LVL 20

Accepted Solution

by:
rauenpc earned 500 total points
ID: 39168096
I believe the spoofing part is normal.

How do you expect to get out to the internet (I mean directly or via the mGRE tunnel)? I see that you have "nat inside" set on the gig interface as well as the tunnel interface, but there is no interface with "nat outside" set nor any general nat statement indicating what should be natted.

If you can ping the ISP's gateway, that would indicate that you are connected correctly. From there I would look into nat to see if that is what's stopping your client's connection to the internet.
0
 

Author Closing Comment

by:cpatte7372
ID: 39168360
Cheers
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
In the world of WAN, QoS is a pretty important topic for most, if not all, networks. Some WAN technologies have QoS mechanisms built in, but others, such as some L2 WAN's, don't have QoS control in the provider cloud.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

856 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question