Solved

H3C Switches - SNMP v3

Posted on 2013-05-15
1
763 Views
Last Modified: 2013-09-05
Dear Sir,

My company have four H3C 52 port switches but only one of them contain IP address for management, we called main switch. Main switch use four fiber cables to connect the other three switches.

We use Whatsupgold 16.1.1 to monitoring the port status via SNMP v3 protocol. But it only shows the main switch snmp port only. Am I missing something?

Thank you for your help.

With regards,
Wataw
0
Comment
Question by:Wataw
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 17

Accepted Solution

by:
TimotiSt earned 500 total points
ID: 39171719
Hi Wataw,

If you didn't stack those switches (if they can be stacked at all), then they'll need to be managed as separate devices:
You'll need a management IP on all of them and set up SNMP credentials on them.

Tamas
0

Featured Post

Free learning courses: Active Directory Deep Dive

Get a firm grasp on your IT environment when you learn Active Directory best practices with Veeam! Watch all, or choose any amount, of this three-part webinar series to improve your skills. From the basics to virtualization and backup, we got you covered.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
fibre channel switch - sfp needed? 2 55
Internet monitoring software 5 51
2960 not recognizing subinterface configuraton of 5510 11 59
Voice QoS 3Com 5500G 5 27
Introduction Many times we come across a slowness or instability between two hosts, and almost always we blame the poor networking guys, just because they're an easy target.  Sometimes we forget that other factors including disk bottlenecks, CPU …
This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices. This guide can be used on the following Ubiquiti AirMAX devices. Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. Please review …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

756 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question