Solved

Command for showing routes on Cisco 1800?

Posted on 2013-05-20
1
259 Views
Last Modified: 2013-05-20
hi guys,

Can you tell me how to show the list of routes set on aCisco router? What command would I type?

thanks
yashy
0
Comment
Question by:Yashy
1 Comment
 
LVL 8

Accepted Solution

by:
jpgobert earned 500 total points
ID: 39180552
show ip route
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

I recently updated from an old PIX platform to the new ASA platform.  While upgrading, I was tremendously confused about how the VPN and AnyConnect licensing works.  It turns out that the ASA has 3 different VPN licensing schemes. "site-to-site" …
In the world of WAN, QoS is a pretty important topic for most, if not all, networks. Some WAN technologies have QoS mechanisms built in, but others, such as some L2 WAN's, don't have QoS control in the provider cloud.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

762 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

23 Experts available now in Live!

Get 1:1 Help Now